NTI VOPEX SERIES SPLITTER/EXTENDER
8
Connect the CAT5 cable
Make sure the CAT5 cable has been installed in accordance with the
“Preparation for Installation” instructions on page 3. Connect the CAT5 cable to
the “Cat 5” port on each Remote Unit. (See Fig. 4) When properly inserted the
CAT5 cable end should snap into place.
Note: If an RJ45 wall outlet is being used, connect the other end of the
extension cable to the RJ45 wall outlet.
WARNING: Never connect the XTENDEX to an Ethernet card,
Ethernet router, hub or switch or other Ethernet RJ45 connector of an
Ethernet device. Damage to devices connected to the Ethernet may
result.
Figure 4- Connect the CAT5 cable to the Remote Units
Up to 600 feet of CAT5 cable can be installed between the VOPEX and any ST-C5V(A)-R-600 Remote Unit.
Up to 1000 feet of CAT5 cable can be installed between the VOPEX and any ST-C5V(2A)-R-1000SP Remote Unit.
Use the charts on page 13 to determine what length of cable can be used for the desired resolution.
!
