NSS WRANGLER 20W/D, Руководство пользователя

Страница: 4 / 24

SQUEEGEE ASSEMBLY
Remove the squeegee assembly from the box and inspect for concealed damage.
The squeegee assembly has a wide, flat frame to help prevent damage, two (2) mounting knobs, and
two (2) small wheels to prevent “rollover” while in reverse.
To Install the Squeegee Assembly:
*
Place the squeegee lift arm in the storage (up) position.
* Loosen the two mounting knobs and slide the squeegee assembly onto the mounting plate. The
roller wheels must face the operator.
* Hand tighten the mounting knobs. Do not use pliers to tighten the knobs as this will defeat the
“breakaway” design.
To Adjust the Squeegee Assembly:
As the machine is used, the squeegee blades wear out, and need to be replaced due to damage.
Some adjustment may be needed.
* Squeegee blades should lay over slightly (like a window squeegee) whenever the machine is
moving.
* Adjust the blade angle by turning the wing nut on the pivot arm.
* Do not add any weights or other pressure to the squeegee mechanism, it will not improve the
performance or service life.
MACHINE MAINTENANCE
Daily Maintenance
*
Recharge the batteries at the end of every shift.
* Empty and rinse clean the recovery tank.
* Remove and rinse clean the squeegee assembly.
* Remove and rise clean the pad driver and / or brush.
* Inspect the machine components for wear or damage. Repair or replace as needed.
Weekly Maintenance
*
Verify that all daily maintenance has been performed.
* Inspect the battery liquid level, adjust to the proper level as needed.
* Check all battery terminal and cable connections. Tighten as deemed necessary.
* Clean any corrosion from the battery terminals and cables.
* Check the solution flow to the pad driver and / or brush. Flush clean the solution tank and hose with
a mixture of 8 oz. (250ml.) of white vinegar to 1 gallon (4 liter) of warm water.
Monthly Maintenance
*
Verify that all daily and weekly maintenance has been performed.
* Lubricate the drive wheels, bearings, the caster axle, and swivel bearing. Use a high grade water
resistant grease.
After every 750 Hours of Operation:
*
Inspect the drive motor (transaxle) carbon brushes for wear.
Replace the brushes when they are 3/8 in. (9mm.) in length.
* Inspect the brush drive motor carbon brushes for wear.
Replace the brushes when they are 1/2 in. (13mm.) in length.
* Inspect the vacuum motor carbon brushes for wear.
Replace the brushes when they are 7/16 in. (11mm.) in length.