NSS WRANGLER 20W/D, Руководство пользователя

Страница: 2 / 24

MACHINE INSPECTION
*
Carefully unpack the Wrangler 20 W/D, and recycle all packing materials.
* Inspect the machine for damage or missing components. If damage is found, contact the local
freight company to file a freight claim.
MACHINE COMPONENTS
Solution Tank
The solution tank is the lower part of the machine body. This tank has a capacity of 14 gallons , and is
filled by pouring the water and cleaning chemicals through the filter in the square opening in the corner
of the lower tank.
Recovery Tank
The recovery tank is the upper part of the machine body. This tank has a capacity of 14 gallons , a
round, clear view lid assembly, closes the tank. In this tank is a foam sensitive float shut-off assembly,
as the water level rises, the float ball will rise into the tube and shut off the air flow of the vacuum, it
does not shut off the vacuum motor.
CONTROL PANEL
The operator control panel is located at the upper rear of the machine. This panel has components that
control various machine function. Starting on the left side of the control panel:
* The battery meter shows the state of charge of the batteries during operation and recharge.
* The first toggle switch turns the brush motor “ON and OFF”.
* The next toggle switch turns the vacuum motor “ON and OFF”.
* The next toggle switch controls the direction of the machine and has three positions: forward,
neutral, and reverse.
* The last toggle switch on the right controls the speed of the machine and has three positions:
low, neutral, and high.
* The top circuit breaker is for the brush motor and is rated at 30 Amps.
* The bottom circuit breaker is for the drive motor and is rated at 10 Amps.
BATTERY PACKAGE
The Wrangler 20 W/D is a 24 volt system and is available with two battery packages:
* Two (2) 12 volt batteries.
* Four (6) volt batteries.
Consult your local NSS authorized distributor for application recommendations.
To Install The Batteries
* Turn off all switches and place the speed and direction switches in the neutral position. Lower
the brush motor to the floor. Loosen the black knob and raise the recovery tank, use the support
arm to hold up the tank.
* For ease of installing the batteries you may wish to completely remove the recovery tank.
Remove the two (2) hinge pins under the front of the recovery tank.
* The batteries are heavy - use two people to install them.
* Refer to the wiring diagram on the back of the control panel. Align the batteries in the
compartment as shown on the diagram.
* Install the battery cables as shown on the wiring diagram. Tighten the bolts and hex nuts with a
wrench.
* Loose or improper battery connections will cause battery or machine damage and possible
injury.