Brush Switch
•
The brush switch is located on the left side of the
control column and it turns the brush on and off.
•
There is also a tilt switch in this circuit located under
the brush head that only allows the brush to be turned
on when the brush head is in the operating position.
Circuit Breaker
•
There is one master circuit breaker located below the
brush switch on the control column.
Brush Head
•
The brush motor, Filter Bag and Flexiwall shield are
located at the front of the machine.
•
The bag connects directly to the Flexiwall shield and
has a snap that retains the rear of the bag.
MAINTENANCE
ALWAYS turn OFF all machine switches
before performing any maintenance or
repairs to any equipment.
Daily Maintenance
Pad Installation / Changing
There is a wide range of pads available for many
different burnishing applications. Consult your local NSS
authorized distributor for application recommendations.
•
Lift the front of the machine up to the 90 degree
position to view the pad driver and pad.
•
Make sure that the correct pad size is installed.
Charger 2717 AB requires a (7/8" to 1") X 27" pad
and a Charger 2022 AB requires a (7/8" to 1") X 20"
pad.
•
Place the pad flat on the floor, and remove the center
hole of the pad, step on the center of the pad to
compress the edges around the center hole. This
allows for easier installation of the pad centering cup.
•
With the machine in the pad changing position,
carefully center the pad on the driver.
Caution
: Pads must be installed concentric (evenly
aligned) with the outside edge of the pad driver. Failure
to follow these precautions will cause excessive
machine vibration, a reduction in pad life and produce
unsatisfactory burnishing results.
•
Place the pad grabber in the center hole of the pad.
•
Holding the pad driver and pad, push on the pad
grabber until the spring clip has clicked twice.
Caution:
Failure to install the pad grabber tightly may
allow the pad to be thrown from the driver.
https://harrissupplyind.com - To Order Parts Call 608-268-8080