6
7
POWER RANGE
Low
High
2) Insert the Tip through the hole of the Tip Wrench, align the
four cornered tip's base into the hole of the Tip Wrench. Turn
it clockwise until it clicks.
· To remove the Tip, turn counterclockwise with the Tip
Wrench.
Fig. 9
CAUTION
CAUTION
(3) Power On
Connect the Power Cord to the wall outlet. Turn on the Power
Switch of the Control Unit. Front Panel will light up.
(4) Power Setting
1) Select the Operating Mode with the Mode Selection Keys on the Front Panel. The light over the selected mode will
illuminate.
Do not use any wall outlets other than those of
AC120V±10% or AC230V±10%. There is a risk that
the Power Cord could be damaged.
CAUTION
· When mounting and/or removing the Tip, always
use groves.
· Tip, Tip Wrench, and Handpiece that have been
sterilized.
· Tip Wrench is consumable For reliable operation
replace annually.
Check the case the selected Tip came in for proper
power.
You can check Maximum Power on the Tip Case Label.
Check your model.
Fig. 10
Output for each mode
Set to
(General)
Mode
Selection
key
(Endo)
Set to
Set to
(Perio)
Tip Wrench
Tip Wrench
Tighten
Tighten
Tighten
Tighten
Loosen
Loosen
Loosen
Loosen
Model
Maximum Power
CAUTION
Always use the water supply unless you are doing
procedure requiring Dry Mode(No Irrigation Mode).
If water supply is insufficient, handpiece will overheat
patient’s tooth surface can be injured.
2) Set the Power Level with the Power Level Key on the Front
Panel. The lamps in the Power Display Panel will indicate the
selected power level. Check to make sure the Power Level is
set in the appropriate range for the selected Tip.
Fig. 12
NOTICE
· Continuous pushing of the Power Level Key will cause the Power Level Display to climb.
· When only water is desired without oscillating the Tip, keep pressing “Decrease” key to extinguish Power Display
Pannel Lamp.
(5) Water Mode Selection
Push the Water Key to select whether or not to supply water.
(When the lamp illuminates, water supply becomes available.)
Fig. 13
CAUTION
(6) Operate Varios 560 LUX, Varios 560
· Depress the Foot Control. Tip will vibrate. (If the lamp stays illuminated by pushing the Water Key, water supply will
also start.)
· The Operating Lamp stays illuminated while the Tip is vibrating. (Fig.14) The handpiece ring light also illuminates.
(Varios 560 LUX)
· Adjust the Power Level to the proper range.
· Turn the Water Adjustment Knob counterclockwise gradually to increase the supply volume. (Fig.15)
· Always use the water supply unless you are doing procedure requiring Dry Mode. If water supply is insufficient,
handpiece will overheat patient´s tooth surface can be injured.
· Prior to starting the procedure, verify that the water spray is clean and at adequate volume.
Fig. 14
Fig. 15
Fig. 11
Front Panel
Power Switch
Front Panel
Power Switch
Water Adjustment Knob
Water Adjustment Knob
Operating Lamp
Water Key
Lamp
Power Level Key
Decrease
Increase
Power Level Display Panel
