11
K1
TM
Assembly Instructions
1. Slide linear bearing on to the linear rail, using the plastic provisional rail supplied.
2. Remove the grease fitting from the end of the bearing.
3. Remove the Phillips screws (2 pieces).
4. Remove the end seal from end of bearing.
5. Install threaded plug from K1
TM
kit (or see option 9 and 10 depending on
application).
6. Install the cover plate from the K1
TM
kit, to the end of bearing, against the end
cap.
7. Install K1
TM
lubricating unit without fixing rings, so it can be expanded over the
rail.
8. Put the three (3) fixing rings in position on the K1
TM
lubricating unit.
9. Replace the end seal, in front of the K1
TM
lubricating unit.
10. Install connector screw for grease fitting.
11. Replace the grease fitting in connector screw.
12. Install the
extension
Phillips screws (2 pieces, supplied with the K1
TM
seal kit).
Note
The K1
TM
lubricating unit has a shelf life. They should be installed immediately upon receipt. It is important
to avoid direct sunlight and extreme heat conditions.
