6
›
Place the IHN800 in the horizontal position on a stable surface�
›
Connect the mains plug to a suitable mains supply�
›
For workpieces with an internal diameter (>186mm) large enough to fit over the inductive coil, follow these steps:
›
Place the workpiece over the inductive coil using appropriate lifting equipment�
›
For best performance, adjust the position of the workpiece so that the inductive coil is in the centre�
›
Remove the protective film from the bright underside of the sliding yoke before the first use�
›
Slide the sliding yoke to the right so that it completely covers the top of both vertical supports�
›
For workpieces that do not fit over the inductive coil, these should be heated on the horizontal yoke�
›
If you will use TEMP MODE, plug the temperature probe into the connector on the left side of the heater�
Place the magnetic end of the probe on the inner ring of the bearing or on the innermost surface of the workpiece�
›
Switch the IHN800 on using the power switch on the left side�
4 Preparation for Use
