11
7 Troubleshooting
Display
Fault
Action
E01 E
General system failure
Return heater for repair
E02 E
Memory failure
Return heater for repair
E03 E
Overheated coil
Wait until the inductive coil cools
E04 E
Not in use
E05 E
Temperature increase of less than 1°C (2°F) every
15 seconds (or 1°C (2°F) every 30 seconds)
Check the temperature probe connection� If the connection
is OK, select the 30 second interval as described in section 6
or operate the heater in TIME MODE�
E06 E
Temperature probe not connected (or defective)
Check the temperature probe
E07 E
Failure during current measurement
Return heater for repair
E08 E
Failure during communication with power printed
circuit board
Return heater for repair
E09 E
Overheated printed circuit board
Wait until the printed circuit board cools�
8 Spare Parts
Description
Part Number
Spare temperature probe
IHNP2SENSOR
Spare protective gloves
IHNGLOVES
Spare set support yoke 55 x 55 x 100 mm for IHN080/120
IHN080/120-YS
Spare yoke 10 x 10 x 275 mm for IHN080/120
IHN080/120-Y1
Spare yoke 14 x 14 x 275 mm for IHN080/120
IHN080/120-Y2
Spare yoke 20 x 20 x 275 mm for IHN080/120
IHN080/120-Y3
Spare yoke 28 x 28 x 275 mm for IHN080/120
IHN080/120-Y4
Spare yoke 40 x 40 x 275 mm for IHN080/120
IHN080/120-Y6
Spare yoke 55 x 55 x 275 mm for IHN080/120
IHN080/120-Y8
Spare swivel arm complete for IHN080/120
IHN080/120-SA
A system fault will be indicated by an acoustic signal and one of the following fault codes on the main display:
