Parts sealed by the manufacturer or its agent should not be disassembled by the user. Do
not modify any part of the barbecue. Repairs and maintenance should only be carried out
by an accredited technician.
The barbecue should be used in a well ventilated area. Do not obstruct the flow if combustion air to
the burner when using the barbecue. THIS BARBECUE IS ONLY FOR OUTDOOR USE.
IDENTIFY ANY LEAKS BEFORE USE.
Never look for leaks with a naked light; always use soapy water.
TAKE GREAT CARE!!!
If there is a gas leak, switch off the gas supply immediately.
LEAK TEST
Mix one part washing up liquid to three parts water to make 60 to 90 ml of leak finding solution.
Ensure that the control valve is closed.
Connect the regulator to the cylinder and the open/close valve to the burner. Ensure that
connections are correctly made and then open the gas inlet valve.
Spread the solution over the hose and all joins with a brush. If any bubbles appear, then there
is a leak, which must be repaired before the barbecue is used.
Test again, once the leak is repaired.
Close the gas inlet valve on the cylinder, when the test is complete.
If a leak is detected which cannot be repaired, do not attempt any other action but contact your
distributor.
Lighting Instruction
1.Open hood before igniting the BBQ burners.
2.Ensure all control knobs on the BBQ are in the OFF position.
3.Open the gas control valve on the LPG cylinder slowly and smoothly.
4.From the OFF position, push in and turn one control knob anti-clockwise to the HI position.
A clicking sound will indicate the sparking of the ignitor for the pilot flame.
5.The pilot flame will shoot down the side of the burner to effect quick burner ignition.
6.If burner does not light after 5 clicks, turn OFF,wait 2 minutes and repeat procedure.
7.The same procedure should be used to light remaining burners.
Warning : Only barbecue at a
LO
setting if the hood is closed !
Notice for first time using
Turn on the barbecue following above instructions.
Close the hood and left the gas burn at LO setting for 15 minutes.
The smells from the treated surface are eliminated by the high temperature
.