5
2.7 MEMORY PROGRAMMING
The one-touch memory buttons can be programmed as
follows:
- Press [SPEAKER ON]
- Press [STORE] (located under memory label)
- Press [M1], [M2], [M3] or [M4]
- Enter the telephone number to store
- Press [STORE]
- Press [SPEAKER ON] to end procedure.
2.8 RINGER SET UP
The ringer volume and ringer melody can be adjusted as
follows:
RINGER VOLUME
LOW - Press [SPEAKER ON][STORE][6][1][STORE]
MED - Press [SPEAKER ON][STORE][6][2][STORE]
HIGH - Press [SPEAKER ON][STORE][6][3][STORE]
RINGER MELODY
MELODY 1 - Press [SPEAKER ON][STORE][7][0][STORE]
MELODY 2 - Press [SPEAKER ON][STORE][7][1][STORE]
MELODY 3 - Press [SPEAKER ON][STORE][7][2][STORE]
MELODY 4 - Press [SPEAKER ON][STORE][7][3][STORE]
MELODY 5 - Press [SPEAKER ON][STORE][7][4][STORE]
Setup & Operation
RINGER ON/OFF
ON - Press [SPEAKER ON][STORE][9][1][STORE]
OFF - Press [SPEAKER ON][STORE][9][0][STORE]
3. OPERATION
3.1 DIALLING
To dial a new call first press [SPEAKER ON] and
listen for dial tone. Once you hear dial tone, dial the
number either using the keypad or by using one of
the three memory buttons. Once the other party
answers, speak clearly in the direction of the
microphone at the front of the unit. To terminate the
call press the [SPEAKER ON] button again.
3.2 REDIAL
After pressing the [SPEAKER ON] button, by
pressing the [REDIAL] button you can dial the last
number dialled on the unit.
3.3 PAUSE
Pressing the [PAUSE] button either during a dialling
sequence or when programming one of the memory
buttons will insert a 3 second pause.
4
Operation
3.4 SPEED DIALLING
When you are on line, pressing one of the memory
buttons [M1], [M2], [M3] or [M4] will dial the number
stored in that memory location.
3.5 RECALL
The [RECALL] button can be used to access
additional PBX or network operator services. The
telephone supports both Earth and TBR recall (See
section 2.4).
3.6 VOLUME CONTROL
While the telephone is on line, the receive volume
control can be adjusted by pressing the [+] and [-]
volume buttons. The volume level will be
remembered by the unit for the next call after the
telephone goes off line.
3.7 MUTE
If you wish to put the phone call on hold for a while or
pick up the call on another telephone connected in
parallel, this can be done by using the [HOLD] button.
Once the [HOLD] button is pressed the call is placed
on hold and the hold indicator is turned on. To
resume the call, press the [SPEAKER ON] button
and resume conversation.
Alternatively, pick up another telephone connected
in parallel with the NRX Flatphone and the hold
indicator will be turned Off.
