NRI v2 eagle, Руководство по эксплуатации

Страница: 37 / 57

BA_v2_eagle_parallel_EN_1-0
37
o
peRaTion
7.3 Teaching coin channels in teach mode (optional)
If the v
2
eagle has been programmed accordingly in the factory, up to eight coin channels (teach
channels) can be taught on the coin validator via the bottom switch block in order to create new
acceptance bands. You need at least ten coins/tokens of the new type. In the teach mode, the
following DIL switches have the following functions:
DIL switch
Function OFF ON
S2.1 Teach mode – Teach channel 9
S2.2 Teach mode – Teach channel 10
S2.3 Teach mode – Teach channel 11
S2.4 Teach mode – Teach channel 12
S2.5 Teach mode – Teach channel 13
S2.6 Teach mode – Teach channel 14
S2.7 Teach mode – Teach channel 15
S2.8 Teach mode – Teach channel 16
S2.9 Teach mode OFF ON
Proceed as follows to assign a new coin/token to coin channel 9–16 of the active memory block:
Please note the current switch positions to be able to reset the switches to these
positions for normal operation.
1
Unhook the coin validator from the machine.
2
Set DIL switches S2.1–9 to OFF (down).
3
Set DIL switch S2.9 upwards to ON.
The device is in the teach mode for teaching the coin
channels.
4
Select the coin channel to be taught (9–16, here: 11) by
setting the corresponding DIL switch (S2.1–8, here: S.2.3)
upwards to ON.
5
Insert at least 10 coins of the new coin type/token into the coin validator or machine.
After the 10th coin has been inserted, the acceptance gate is operated once (brief
clacking sound). Further coins can be inserted.
If there is no signal after the 10th coin has been inserted, the coins inserted
cannot be used.
Now you can save the measured values generated by the inserted coins with a normal (a) or a
wide (b) acceptance band. A wide acceptance band is an appropriate choice when you only have
a limited selection of coins at your disposal for the purpose of teaching tokens.
S2
S2
S2