Page of 15
13
PLEASE MAKE SURE TO CONNECT THE BATTERY TERMINAL TO THE CORRECT BATTERY
TERMINAL CABLE
Battery Installation Procedures:
(1) Turn OFF ALL for PowerTunes (includes: Jumpstart, AC, USB, Radio, and Compressor)
(2) Unscrew the back cover of the powertunes (total 5 screws)
(3) Remove the back cover
(4) Pull out the internal battery out a little to unscrew the battery terminal connection.
(5) Remove the damaged or dead battery from housing
(6) Place the correct new battery into housing
(7) Connect the red battery terminal cable to the red positive (+) terminal of your battery. Fasten the
screw as below picture.
Note: Make sure the screw was fastened as possible as you can. If it is not fasten well, Jump Starter
capability will be impacted.
WARNING:
Make sure red terminal cable is connected with red battery terminal. DO
NOT REVERSE POLARITY. Otherwise, it may damage the PowerTunes or even your vehicle
when using it to boost vehicle.
(8) Connect the two black terminal cables to the black negative (-) terminal of your battery. Fasten
the screw as below picture.
Note:
1. There are two black terminal cables. Both of them should be fastened to the battery terminal to
make PowerTunes work properly.
2. Make sure the screw was fastened as possible as you can. If it is not fasten well, Jump Starter
capability will be impacted.
WARNING:
Make sure red terminal cable is connected with red battery terminal. DO
NOT REVERSE POLARITY. Otherwise, it may damage the PowerTunes or even your vehicle
when using it to boost vehicle.
(9) Put back the back cover and tighten the 5 screws.
Note: Make sure the hose of compressor is in the slot of back cover to prevent it being damaged.
Refer to below picture
