7.
Control panel functions: the up/down
adjustment button
7.1
System initialisation / First start-up
7.2
Height adjustment
16
EN
To ensure correct operation, the workstation base needs to be initialised before first use.
Note:
Use only the control module provided by the manufacturer for each specific
product type. The adjustment range limits have been set at the factory.
Danger:
The anti-collision function is not active during an initialisation or reset proce-
dure. Please always be mindful of a potential risk of crushing during those procedures.
| Press and hold the “
down
” button until the workstation reaches its lowest position, then release the button.
The same function applies if the wires connecting the columns with the control module have been discon-
nected. If the control module is forcing initialisation, the workstation can only move “
down
” at slow speed.
Releasing the button too early may cause the workstation to malfunction. If this happens, the initialisation
procedure must be repeated.
To decrease desk height:
| Press and hold the “
down
” button until the
desired height is reached.
The “down”/”up” movement of the desk will continue until you release the button or until the lowest/highest
possible position is reached.
On uneven floor, use glides to level the workstation before adjusting its height.
To increase desk height:
| Press and hold the “
up
” button until the desired
height is reached.
