Nowsonic autark id07, Руководство пользователя

Страница: 10 / 76

10
Nowsonic Autark ID07
User manual
GB
www.nowsonic.com
4. BATTERY SWITCH
This button activates the operation of Autark ID07 via the internal
battery pack. The internal battery pack is automatically charged when
Autark ID07 is connected to the mains. The charging capacity of the
battery pack is displayed on the battery indicator
(6)
.
5. Remote antenna
The antenna is connected to the internal DMX receiver of Autark ID07.
Unfold the antenna to improve the reception quality for remote con-
trolling.
6. Battery indicator
These LEDs show the current charging status of the internal battery
pack: when fully charged (all LEDs are lit), Autark ID07 can be operated
up to 10 hours without mains supply.
7. Signal LED
When the automatic sound control mode is active, this LED lights
depending on the sensitivity set in the
S! Ln5
menu (see from page 7
on). The brighter the LED lights up, the higher the sensitivity is.
8. DMX IN / OUT sockets
These sockets allow to feed an external DMX signal to Autark ID07 and
to loop thru the incoming DMX signal to following Autark devices.
In Master/Slave mode, the Master device outputs the control signal
via its
DMX OUT
socket, while the Slave unit receives the signal via its
DMX IN
socket.
NOTE:
Please note that the last unit in a daisy chained configura-
tion via DMX or in Master/Slave mode should be terminated by a
termination resistor. Otherwise control problems may arise.
9. Earthing point
This screw allows to connect external devices with the ground of
Autark ID07.
Operation
You can operate Autark ID07 either in Stand-alone or Master/Slave
mode or wired and remotely controlled respectively via DMX. In Stand-
alone mode, the sound sensing is automatically activated and toggles
the internal programs depending on the detected music signal.