Novy 2961, Инструкции по эксплуатации и монтажу

Страница: 40 / 76

40
EN
Safety Instructions
WARNING!
Before connecting the appliance compare the
power data (voltage and frequency) indicated
on the characteristics plate with those of the
power supply in question. If these data do not
match there may be problems. In case of
doubt, contact an electrician
.
WARNING!
If the electrical wire plug is removed, the
appliance must be installed and connected by
a technician. Contact a qualified electrician
who knows and respects current safety
standards. The manufacturer cannot be held
responsible for damage resulting from fitting or
connecting errors.
WARNING!
The electrical safety of the appliance can only
be
guaranteed if it is earthed. The
manufacturer cannot be held responsible for
damage resulting from the absence of or
defects in the instal
lation’s protection system
(e.g. electrical shock).
WARNING!
Only use the appliance once it has been fitted
into its built-in position. Only in this manner can
it be guaranteed that users cannot access the
electrical components.
WARNING!
Never open up th
e appliance’s frame. Possible
contacts with electrical conducting parts or
changes
to electrical or mechanical
components may represent a danger to users’
safety and prejudice the correct working of the
appliance.
WARNING!
Repairs and maintenance, especially of parts
carrying electrical current, must only be done
by technicians authorised by the manufacturer.
The manufacturer and retailers do not accept
responsibility for any damaged caused to
people, animals or property as a result of
repairs and maintenance carried out by non-
authorised personnel.
WARNING!
Repairs undertaken during the guarantee
period must only be done by technicians
authorised by the manufacturer. If this is not
the case then any damage resulting from the
repair in question is excluded from the
guarantee
WARNING!
The appliance must be disconnected from the
electrical current when installation and repair
work is being done. To disconnect the
appliance from the current, one of the following
conditions must apply:
•
The switchboard fuses / circuit breakers
must be disconnected.
•
The plug should be removed from the
socket. To remove the plug from the socket do
not pull on the electric cable but rather pull out
the plug itself directly.