www.nvcnc.com
Chapter4 Setting of softwar
e
Manual of NVUM_SP
- 26 -
Figure4-8.
Pin&Port Dialog
The sub-pages you need to set include “Motor Outputs”, “Input Signals”, “Output Signals”
and “Spindle Setup”.First Click to enter “Motor Outputs”. This page is to select the stepper motor
control pin. Because our usbmach3 interface board stepper motor signals are fixed, So here only
need to Select, no need to select the specific pin. See as Figure4-9
To make the Z axis to the same direction, Z axis’s “Dir low” should be set to”
√
”.Other
axes’s should be set as system need.
Figure4-9.
Stepper motor port settings dialog
Click “Input Signals” Into the input signal settings page. See as Figure4-10
