NVR
-
6316
-
H1
-
II
User
’
s manual (Short) ver.1.0
All rights reserved © AAT Holding S.A.
7
STARTING THE DEVICE
After enclosure, mount the disk using mounting screws (4 pcs.), And then connect the power cord and
signal.The recorder casing has 6 holes enabling adaptation to hard disk mounting holes.
After connecting the hard drive mount the cover start the NVR to check and format the hard drive.
WARNING:
If the disk used has been used in another device, it must be formatted. The formatting process
results in the loss of data saved on the disk.
2.3. Connecting the power supply.
To start please connect provided power cord in the rear power port of the NVR like depicted below.
Initialization lasts approximately 60 seconds. During this time executing any device functions and
pressing any buttons is prohibited. To shut down the device please use the menu.
CAUTION:
Make connection when the power is not applied.
Do not place the power cord under the carpet or rug. The power cord is usually earth
-
grounded.
However, even if it's not earth
-
grounded, never modify it on your own for earth
-
grounding.
Make sure that power adapter is placed near of NVR and secured from accidental disconnection.
If the device was brought from a location with lower temperature, please wait until it reaches the
temperature of location it is currently in. Turning the device on immediately after bringing it
from a location with lower ambient temperature is forbidden, as the condensing water vapour
may cause short
-
circuits and damage the device as a result.
Before starting the device familiarize yourself with the description and the role of particular
inputs, outputs and adjusting elements that the device is equipped with.
