NVIP
-
5VE
-
4232M Quick start guide version 1.0
All rights reserved © AAT SYSTEMY BEZPIECZEŃSTWA Sp. z o.o.
7
2.3. "Two way power" function
The camera is equipped with the "Two way power" function. When the camera is connected to the PoE
switch, 12VDC is available in the 12V camera power socket. This allows user to power the receiver
with low power consumption, e.g. a microphone, from the camera power socket.
2.4. Camera mounting
To mount a camera please follow the instructions below:
•
Remove the retaining ring (A) by turning it counter
-
clockwise
•
Remove the camera cover (B), remove the camera from the base
•
Use the template or the location of the holes on the base of the camera to mark the points for
future mounting holes and cable entry.
•
Drill holes in accordance with previously done markings .
•
Mount the camera base using the supplied dowels and screws.
•
Connect the camera cables, put camera on the base, attach the cover (B) and pre
-
tighten the
retaining ring (A)
•
Adjust the position of the camera
•
Tighten to the stop retaining ring (A)
Caution:
Please note that the wall or ceiling must have enough strength to support the camera.
Caution:
The declared degree of protection of the camera relates to its housing and does not take into
account the possibility of moisture infiltration into the interior of the camera by connecting
cables. Connection cables protection through i.e. sealing up is the responsibility of the camera
installer. The manufacturer is not liable for any damages to the camera caused as a result of
failing in performing that activity by installer, which also means that camera damaged in that
way is not subject to warranty repairs.
START
-
UP AND INITIAL CONFIGURATION
The maximum power consumption of the device using the
“
Two way power
”
function is 3W.
A
B
