NVIP
-
5DN3625AV/940IR
-
1P
-
User
’
s manual (short form) ver 1.0
All rights reserved © AAT Holding S.A.
10
2.3. Camera mounting
To mount a camera please follow the instructions below:
•
Unscrew the camera cover (
5
) by turning counter
-
clockwise.
•
Remove the camera housing (
4
).
•
Put the bracket to the wall in a desired mounting place (with cable hole). Take the drill pattern
and mark future drilling holes for screws and wires.
•
Drill holes in accordance with previously done markings and base hole placement.
•
Mount the camera base (
1
) using the supplied plugs and screws.
•
If necessary, mount microSD card in the socket (
3
), than connect the camera wires
•
Adjust camera position, if necessary, connect service monitor, adjust lens using
Zoom +/
-
buttons (
2
).
•
Screw the camera housing (
4
) back on camera.
•
Screw the camera cover (
5
) by turning it clockwise.
CAUTION!
Please note that the wall or ceiling must have enough strength to support the IP Camera.
CAUTION!
In order to obtain declared degree of protection please seal the camera bracket to prevent water
getting inside. Furthermore, when installing the bracket on rough/uneven surfaces, please
additionally seal the junction with appropriate sealing mass. Please pay special attention to any
mounting holes and if they are a loop
-
through ones, seal them too.
START
-
UP AND INITIAL CAMERA CONFIGURATION
1
2
3
4
5
