NVB-5100JBB, NVB-5100JBS, NVB-5100PA - user’s manual, ver. 1.1
All rights reserved © AAT Holding S.A.
9
4. MOUNTING THE JUNCTION BOXES/ADAPTOR
4.1 Mounting the NVB-5100BB/NVB-5100BS junction boxes
1. Pick a suitable location and provide all necessary wiring in desired housing mounting
place.
2. Mark mounting holes and drill them in selected locations.
3. Screw the base to a wall using for anchors (to facilitate the work the lid can be removed)
4. Put the required wiring into the box using holes provided in the box.
5. Put the camera cables through the hole in the lid of the box, plug the hole rubber seal (if
applicable) and screw the camera to the appropriate holes using set of screws.
6. Connect cabling inside the box.
7. Close the lid and screw it using attached screws.
4.2 Mounting the NVB-5100PA pole adaptor
Adapter should be attached to structures or surfaces being able to safely lift the mass both of
the adapter and device attached. To install the adapter, you must do:
1. Select the clamp appropriate to the pole diameter, loosen the assembling screw and slide
the clamp through the slot visible in the adaptor stiffening ribs
2. Put the clamp on the pole on which to be attached the adaptor and screw the clamp.
3. Put the camera cable through the adapter center hole and screw the camera to the
appropriate holes
4. Make the necessary position adjustments and cable connections
Clamping diameter ranges:
Clamp no. 1: 67 ~ 127 mm
Clamp no. 2: 83 ~ 178 mm
MOUNTING
