LoopView
NOVUS AUTOMATION
2/4
0ffs
Offset.
Function that allows changes or corrections to the
PV value displayed by the indicator.
Filt
Filter.
Parameter that defines the value of the filter
applied to the signal processing. Used to improve
the stability of the measured signal.
Configurable with values between 0 and 9 (Value
in seconds of the filter 1).
FvaL
Alarm Function.
LoopView has the ALARM function to indicate
that process critical PV values have been reached.
When a PV value defined as critical is measured
by the indicator, the display interpolates the
presentation of PV value with
AL
message.
The PV value critical to the process is set in
SPAL
parameter.
Three alarm functions are available:
LO
The display should indicate that the PV
value is BELOW the critical value that
has been set (
spaL
).
KI
The display should indicate that the PV
value is ABOVE the critical value that
has been set (
spaL
).
IErr
The display should indicate that the PV
value is out of the defined measuring
range.
Off
Critical value indication is disabled.
spaL
Alarm Setpoint.
It allows you to set the PV value critical to the
process used for alarm indication.
This parameter will not be displayed when Alarm
Function is set to
Off
or
IErr
.
pass
Password.
It allows you to enter the access password. This
will allows you to change the configuration
parameters according to the protection rule set in
the Protection parameter.
Without the password, the configuration can only
be viewed.
(alib
Enable Calibration.
It allows you to calibrate the indicator, showing the
necessary parameters for the procedure
(
INL(
,
INx(
and
Rstr
).
no
Calibration disabled.
yes
Calibration enabled.
When the calibration is not enabled, the
parameters related to this procedure will not be
displayed.
INL(
Lower Calibration Value.
Declaration of the lower calibration value.
INx(
Higher Calibration Value.
Declaration of the higher calibration value.
rstr
Calibration Restore
It allows you to retrieve the last calibration
performed.
no
Do not retrieve the last calibration.
yes
YES, retrieve the last calibration.
pas.(
Setting a new access password.
It allows you to set a new access password,
always different from zero.
prot
Configuration protection.
It allows you to set the level of protection to be
adopted by the indicator.
1
Only special parameters are protected.
2
All parameters are protected.
sn.x
Indicator serial number (Higher part).*
HIGHER part of the indicator serial number.
sn.l
Indicator serial number (Lower part).*
LOWER part of the indicator serial number.
* Serial number composition: 8888 8888 (
sn.x
sn.l
)
