NOVOTEST UT-3M-EMA, Руководство по эксплуатации

Страница: 14 / 24

RDC.ED.UT-3M-EMA.000 OM
Operating manual
EMA Thickness Gauge NOVOTEST UT-3M-EMA
Page. 14
Table 2.2 – “В SCAN” parameters
Groups Parameters
AUTO MIN. MAX.
THRESHOLD
1
THRESHOLD
2
SIGNAL
ACF MIN. MAX.
THRESHOLD
1
THRESHOLD
2
SIGNAL
PIQUE-
PIQUE
MIN. MAX.
THRESHOLD
1
THRESHOLD
2
SIGNAL
FRONT MIN. MAX.
THRESHOLD
1
THRESHOLD
2
SIGNAL
ECHO MIN. MAX.
THRESHOLD
1
THRESHOLD
2
SIGNAL
ECHO-ECHO MIN. MAX.
THRESHOLD
1
THRESHOLD
2
SIGNAL
Description of the “В SCAN” settings:
– “MIN.”: the lowest value of the measurement range;
– “MAX.”: the highest value of the measurement range;
– “THRESHOLD 1” and “THRESHOLD 2”: minimum and maximum measurement threshold;
– “SIGNAL”: turning on/off of the sound signal.
2.3.2.4 “CONTROL” mode
This mode is used when it is necessary to examine the products by the exact thickness (minimum
and maximum). When the measured thickness exceeds the set thresholds, signalization is triggered so
the product can be rejected.
“CONTROL” mode (fig. 2.9) allows operator to estimate the corrosion damage in the percentage
of the reference thickness value.
Figure 2.9 – “CONTROL” mode
All parameters of settings of the measurement in the “CONTROL” mode are divided into groups
(tab. 2.3).
Table 2.3 –“CONTROL” mode parameters
Groups Parameters
AUTO REF. THRESHOLD 2 THRESHOLD 1 SIGNAL
ACF REF. THRESHOLD 2 THRESHOLD 1 SIGNAL
PIQUE-PIQUE REF. THRESHOLD 2 THRESHOLD 1 SIGNAL