NovoPress HP 300, Инструкции по ремонту

Страница: 21 / 46

17
Pressing Cylinder HP 300
4.12 As of serial no.: 3401
Insert and tighten the grub screw (8).
4.13 Insert and tighten the grub screw (34) and arrest it with a centre punch
mark.
4.14 Fit the locating washer (17) into the cap screw (29).
4.15 Place the washer (31) and the spring (25) on the cap screw (29).
4.16 Insert the conical pin (26) into the locating washer (17).
4.17 Screw the assembled inlet pressure valve into the cylinder (2).
4.18 Insert the thrust pin (28).
4.19 For HP’s with hand switch only:
•
Screw the adapter (4/31830) into the cylinder (2) and push the shims (5/31830) on to the
adapter (4/31830).
•
Push the hand switch (36) on to the adapter (4/31830).
•
Push the cup washer (6) on to the adapter (4/31830).
•
Tighten the hand switch with the lock nut (3/31830). The groove in the nut (see
enlargement) must point towards the hollow side of the cup washer.
•
Arrest the lock nut (3/31830) by tightening the grub screw (17/31830).
4.20 Insert and fully tighten the plug connector (20).