Novexx Solutions XLP 504, Руководство по обслуживанию

Страница: 28 / 248

Service manual
XLP 504 / XLP 506
05/2018 | 03 28 Service Mechanics
Ribbon unwinding mandrel
Replacing
Tools
• Torx screwdriver, size 10
• Open-ended spanner, size 8
• Allen key 2.0 mm
Removing
1. Remove the rear hood, see chapter Rear hood

on page 23.
2. Turn out the screw [18A] at the end-of-ribbon sen-
sor and remove the sensor.

Leave the sensor cable connected!
3. Detach the spring [18B] from the top end.
4. Remove the nut [19A].
5. Remove all parts from the ribbon mandrel. Before
removing the brake package, loosen both set
screws [19B].
6. Press the ribbon mandrel out of the bearing as
shown [20].
Installation
Perform the installation in the reverse order to the re-
moval. Note the following:

Assembly sequence: See figure [19].

Place the 3 springs with 3 holes distance each into
the holes on the disk [21]. Put some grease on the
springs to prevent them from falling out.

Make sure that the eyelet at the brake package
shows downwards [18].

Shim ring on the inside: DIN 988 12x1x18

Refasten the retaining spring. The ribbon mandrel
must move easily so that the retaining spring can rotate
it back to its initial position.

When refastening the sensor, make sure that the
timing disk engages into the fork without touching it.

After assembling, set the assembly braking torque;
see Setting the braking torque

on page 31.
[21] Insert the springs leaving 3 holes distance each.
[18] Braking mechanism for ribbon unwinding mandrel.
[19] Removing the brake parts from the unwinding mandrel.
[20] Press the ribbon mandrel out of the bearing.
A
B
A
B
A