06/08 Rev. 4.05-01
USER MANUAL
Setting up
TTX
x50/67x
–
Wildcats/Wildcats plus
–
S 45/65/95/105
–
TDI/STDI/XXTREME
12
Adjusting the print head position
The print head 0-line can be variably adjusted
from 2 mm (from the left edge of the label) to
13 mm
(does not apply for TTX450/S45/Puma).
1. Undo the thumb screw and push the
print head to the desired position.
The print head must not be detached!
2. Tighten the screw again.
3. Use a 2 mm Allen key to loosen the
black plastic disks (on the ribbon rewind
and unwind pins).
4. Adjust the plastic disks to the same
position as the inside of the print head.
5. Tighten the screw again.
Setting the material
thickness
TDI / STDI / XXTREME
To draw in strip labels, you must make an
adjustment for thin or thick materials.
The adjusting wheel (1) is located between
the paper pull-off from the magazine and the
red material guide in a recess in the base
panel. It can be recognized by the plastic
arrows (2) which are attached to it in red,
yellow and green.
Turn clockwise for thin material (error:
two and more labels are being inserted)
Turn anti-clockwise for thick material
(error: no label is being inserted)
The colored plastic arrows enable you to mark
the various material thicknesses if different
grades of material are to be processed.
A position can be changed by keeping hold of
the adjusting wheel while moving the plastic
arrow at the same time.
1
2
