06/08 Rev. 4.05-01
USER MANUAL
Setting up
TTX
x50/67x
–
Wildcats/Wildcats plus
–
S 45/65/95/105
–
TDI/STDI/XXTREME
10
Material photoelectric
switch
General information
A variety of photoelectric switches is available,
depending on the device.
•
TDI/STDI/XXTREME:
– Transmitted light barrier
– Reflected light barrier
•
TTX:
– Transmitted light barrier
– Reflected light barrier
– Full-size light barrier
There is a difference of 11 mm (in the x-
direction, and additive) between the
transmitted light barrier and the reflected light
barrier (optional).
The full-size light barrier (optional) lies behind
the standard light barriers and can scan labels
with perforations. Scanning can take place at
almost any place on the label by means of a
movable sensor block. The minimum label
width is reduced to approx. 38 mm.
Setting
The photoelectric switch (transmitted light or
reflected light) can be adjusted over a range
of 15 mm transverse to the material by means
of the red knob (1) on the front of the print
module.
There is a scale (2) from 0 to 15 on the red
knob.
The set value is calculated as follows:
Punch position - 2 mm = set value
– Punch position:
measured from the left edge of the label
– Set value:
scale value on the knob
Example: Center of the punch from left edge =
11 mm, less 2 mm gives a set value of
9 mm.
For round labels, the punch offset can be set
manually on the printer (parameter PUNO) or
via selection so that the start of the label is
correctly recorded.
2
1
