-32-
ENGLISH
Description of the remote control /30:
Assembly/battery replacement:
Before inserting the batteries, ensure that the power unit is
switched on.
The batteries (supplied) are ALKALINE AAA LR03 1.5V type. When
they run out, they must always be replaced by 2 new batteries of
the same type.
Insert the batteries, being sure to observe the polarity.
NO
OK
AAA 1,5V
AAA 1,5V
Before closing the compartment, check to ensure that the
water-tight seal is still correctly in place.
Description of the remote control:
Once the batteries are inserted, the remote control
searches for the bath with which it will have to communicate.
The bath must therefore be connected to the power supply. To
confirm that this operation has been carried out successfully,
shortly after the batteries are inserted, the pump switches on for
a few seconds.
Your remote control is now ready to use.
To optimise battery life, the display turns itself off 20 seconds
after the last command entered. To restore it, gently press on any
part of the display.
Switching on:
Press the display and hold until the welcome screen appears.
Main commands:
12:33
1
2
3
1- HYDROMASSAGE
2- DISINFECTION
3- OFF (ALL ACTIVE
FUNCTIONS).
Hydromassage menu:
Press button 1 on the main menu to access the
hydromassage menu.
12:33
5
7
10’
4
6
Select the hydromassage desired by repeatedly pressing the
relevant buttons 5 and 6.
Press button 7 to confirm and start the hydromassage.
To have the same hydromassage as last time, simply press button
7 to start
the massage.
To change the duration of the massage, use the duration sub-
menu, which can be accessed by pressing button 4.
5 WHIRLPOOL
OFF
MANUAL
AUTOMATIC
6 AIRPOOL
OFF
CONTINUOUS
TIMED
Hydromassage duration sub-menu:
The + and - buttons can be used to alter the duration of the
massage.
Once the desired time has been entered, press 8 to confirm.
Press 7 if you wish to start the massage.
12:33
8
10’
The display shows the remaining hydromassage time; button 9
is lit to show that the massage is in progress.
12:33
10’
9
NOTE: If the duration of the hydromassage is set to 0, the
massage will run for about 1 hour, starting from the last
command entered.
If there is not enough water in the bath, the symbol 10 will
appear, at which point you will need to add water to start the
hydromassage automatically.
Содержание Una
Страница 62: ...Note ...
Страница 63: ...Note ...