Novell IDENTITY MANAGER 3.6.1 - STAGING BEST PRACTICES GUIDE 2010, Руководство по внедрению

Страница: 24 / 54

24 Identity Manager 3.6.1 WorkOrder Driver Implementation Guide.
no
vd
ocx
(e
n)
17
Sep
te
m
be
r 20
09
or
To skip the configuration settings at this time, click
Finish . When you are ready to configure
the settings, continue with the next section, Configuring the Driver Settings .
4.3.2 Configuring the Driver Settings
After importing the driver configuration file, the WorkOrder driver will run. However, the basic
configuration might not meet the requirements for your environment. For example, you might need
to change whether the driver checks for new work orders in the WorkOrder container at a specific
interval throughout the day or only at a specific time each day. The default setting is to poll the
WorkOrder container every minute.
In addition to the polling setting, there are addtional settings that can help you customize and
optimize the driver. The settings are divided into categories such as Driver Configuration, Engine
Control Values, and Global Configuration Values (GCVs).
To configure the settings:
1
Make sure the Modify Object page for the WorkOrder driver is displayed in iManager. If it is
not:
1a In iManager, click to display the Identity Manager Administration page.
1b Click Identity Manager Overview .
1c Browse to and select the driver set object that contains the new driver.
1d Click the driver set name to access the Driver Set Overview page.
1e Click the upper right corner of the driver, then click Edit properties .
2 Review the settings on the various pages and modify them as needed for your environment.
The configuration settings are explained in
“Driver Parameters” on page 46 .
Although it is important for you to understand all of the settings, your first priority should be to
review the
Driver Parameters located on the Driver Configuration page. These settings let you
control the method the driver uses to check for new work orders.
3
After modifying the settings, click OK to save the settings and close the Modify Object page.
4 (Conditional) If the WorkOrder driver’s Summary page for the Import Configuration Wizard is
still displayed, click
Finish .
WARNING: Do not click Cancel on the Summary page. This removes the driver from the
Identity Vault and loses your work.
4.3.3 Starting the Driver
When a driver is created, it is stopped by default. To make the driver work, you must start the driver
and cause events to occur. Identity Manager is an event-driven system, so after the driver is started,
it doesn’t do anything until an event occurs.
To start the driver:
1
In iManager, click to display the Identity Manager Administration page.
2 Click Identity Manager Overview .
3 Browse to and select the driver set object that contains the driver you want to start.