BEFORE USE
Before first use, fill the kettle with clean water to maximum capacity and boil. Discard the
water and repeat.
OPERATION
The kettle should always be off the base when filling or adding water.
Fill the kettle with water to the desired level. Do not overfill or there will be a risk of
spillage. The water level indicator will assist you to measure correct amount. You
can fill the kettle via the spout or after opening the lid. Do not forget to close the lid
after filling otherwise the kettle will not automatically switch off after boiling.
Do not fill with less than 0,5 L of water.
Do not fill with more than 1,7 L of water.
Place the power base on a dry, flat surface.
Place the kettle on the power base. Only then the appliance is going to work.
Plug the cord into an earthed power socket and switch on by pressing the switch of
the kettle to the “down” position.
When the water has boiled, the kettle will switch off automatically. After allowing the
kettle to cool down for 30 seconds, the water can be brought back to the boil by
pushing the switch back to the “down” position. During the cooling down time do not
force the on/off switch into the “down” (“ON”) position as this can damage the
operating mechanism.
Do not remove the kettle from the power-base without first switching it off.
An automatic safety cut-out has been fitted for protection against overheating.
If the automatic safety cut-out has operated, switch the kettle off, disconnect form
the power outlet and allow the kettle to cool down for 5-10 minutes. Then refill with
water and switch on -the kettle will then boil and cut off.
The kettle may be switched off at any time by either pushing the switch of the kettle
to the “up” position or by switching the power off at the power outlet.
To pour water, lift the kettle from the power base
8
