Novatel Sprint mifi 4082, Начало работы

Страница: 19 / 86

16
Wi-Fi Setup
To properly set up your device, you need to do both of the following tasks:
•
Set Up a Wi-Fi Connection
•
Set Up Wireless Security
IMPORTANT
Your MiFi device might be pre-configured with Wi-Fi encryption (WEP 128 bits)
to prevent unauthorized access to your mobile broadband service. The unique SSID (network
name) and WEP key are printed on the inside of the battery door. You need this information to
continue.
Set Up a Wi-Fi Connection
In most cases, your MiFi device should be pre-configured for your network operator right out of the
box and you can connect normally. [See
Connect to your MiFi device:
(page 16).
]
If it is not pre-configured, setting up the Wi-Fi connection requires two steps:
•
Connect to your MiFi device
•
Configure your MiFi device for your service provider (Not required for most users.)
NOTE
The battery should be fully charged before using MiFi the first time.
To connect in Wi-Fi Mode, your MiFi device must be powered with a charged battery, with an AC
mains, or car charger. When your MiFi device is connected to your computer with the USB cable,
Wi-Fi is disabled.
Connect to your MiFi device:
➊
Press the power button.
Your MiFi device powers on and starts up. When the power LED is flashing and the Wi-Fi LED
is solid blue, the device is ready for you to connect another device (such as your computer) to
it.
➋
Use the normal Wi-Fi manager on your computer to locate the MiFi network name (SSID) and
select it.
NOTE
If your device was pre-configured, the network name was printed on the inside of the battery door.
If your device was not pre-configured, select the network name that has MiFi_4082 in the name.
Tip!
Windows only : The steps to connect to a Wi-Fi network vary depending on your operating system
version and whether you use the native application or third-party software.