APPENDIX C LN-200 IMU in Universal Enclosure
OEM7 SPAN Installation and Operation User Manual v14
293
Figure 120: IMU Bracket
4. Using a 3 mm hex bit, unscrew 4 mm screws and remove the IMU bracket with SDLC, as shown in
Figure 121: Remove IMU Bracket/SDLC
C.2 Install the LN-200 Sensor Unit
To install the LN-200 sensor unit in the Universal Enclosure:
1. Using a 3 mm hex bit, remove original captive 6-32 screws and washers (4 each) from the LN-200 IMU. Add
three washers under each of the original washers and fasten the IMU to the enclosure base, as shown in
ure 122: Install LN-200 IMU to Base
on the next page. Use thread-locking fluid on each screw.
