2
Four screws pass through the housing of the antenna.
Install the antenna as follows:
1. The antenna is supplied with an o-ring. Place it in the o-ring groove of the antenna base.
2. Drill and tap the mounting holes and drill the connector clearance hole on the surface, see the
Mechanical Drawings
section of this guide for details on the mounting pattern.
3. Attach the antenna to the surface using the four mounting screws supplied (use of user-supplied
thread-locking material is recommended). The o-ring compresses and creates a seal between the
surface and the antenna.
Ref. # Description
1
Antenna
2
Countersink screws
3
Mounting surface
4
O-ring
5
Drilled mounting holes
4. Remove the dust cap from the antenna’s TNC connector.
5. Attach the male TNC connector of the coaxial cable to the antenna’s TNC connector:
Ref. # Description
1
Antennas screwed into place
2
Surface
3
TNC connector
4
Coaxial cable
User-supplied o-ring grease can be used to hold the o-ring in the groove during installation.
