Novatech Bitronics 50 Series, Руководство пользователя

Страница: 33 / 118

33
ML0035 September 27, 2017 Copyright 2017 Bitronics, LLC
to poll the 1st IPv4 interface,
inarp -v 50series
CTRL-C stops the scan
to poll the IPv4 interface associated with 192.168.1.1, use
inarp -v -i 192.168.1.1 50series
or to poll a specific mac, use
inarp -v -i 192.168.1.1 00:D0:4F:03:00:15
The inarp utility is Copyright (c) 2011 by Bitronics, LLC. All rights reserved.
Portions of inarp are
Copyright (c) 1999 - 2005 NetGroup, Politecnico di Torino (Italy), and
Copyright (c) 2005 - 2010 CACE Technologies, Davis (California)
3.5.2 Indicators – Ethernet (ACT) & Serial LEDs
There are 2 LEDs on the rear panel to indicate activity is occurring on the
communication ports. These LEDs are useful in determining that there is activity
occurring on the ports. The "ACT" LED will flash to indicate there is activity on the
Ethernet port. It will also indicate that a link has been established. The Serial LED
flashes to indicate there is activity occurring for the serial port.
A troubleshooting guide is found in Appendix A2, which may be useful in establishing
Ethernet connections.
3.5.3 Firmware upgrades and saving and loading configuration files – Ethernet
service port
New versions of firmware may be released by Bitronics from time to time, either to add
new functionality or to correct errors in code that may have escaped detection prior to
commercial release. Consult the factory for detailed information pertaining to the
availability of firmware upgrades. In cases such as this, it is desirable to support a
mechanism for new firmware to be installed remotely. The ability to upgrade Firmware
is done over the Ethernet port. The M650 family utilizes a page in the Web Server
interface to upload and install new firmware.
The complete M650 configuration, which includes all user-configurable parameters,
can be saved in a single file on your computer. This allows you to save a backup of
your configuration and to restore it at a later time, as needed. This also allows you to
configure one M650 and then transfer the configuration to multiple other M650’s.
Before initiating the firmware upgrade, if you are planning to use a configuration that
has already been setup in the M650, then you should first go to the Load/Store
Settings page and click on the Get File button to save the IED configuration to your
computer (if you will be using a default configuration this step is not necessary). Use
the File Save dialog window to select the location on your computer to save the
configuration file. Once you have saved the file, it is recommended that you load the
file back to the M650 to validate that it was saved correctly. Click the Browse or