12 of 33
xDR-DSP
– Diver Intercom Manual
Build 39 Date: 30-08-2021
Menu
The xDR has a menu which can be accessed using the 2 line LCD display and the rotary encoder switch. By default the
xDR display shows the Vol. Tender, which is the audio volume of the Tender internal speaker and headset. By rotating the
encoder switch the Volume can be increased and decreased.
The xDR is based on an internal firmware for control and the DSP. Both can be updated. Please check the
website regularly for any updates.
Startup display
When you switch on the xDR radio the display will show by startup display. By default this is the Volume Tender control.
That means when you use the rotary switch you will increase or decrease the Tender Volume. In the system configuration
with only a xDR Diver intercom, it will also show the internal battery status and lifetime.
In the menu you can select 3 of the below options you want to control in the Startup display
1.
Vol. Tender
:
The Volume of the Tender, which is the volume of the internal speaker and headset
when connected. The scale is from 0 -100% of full power.
2.
Vol. Ext. Speaker
:
The volume of the separate amplified external speaker. The scale is from 0 -100% of
full power.
3.
Comms Mode
:
The type of comms modus settings
Battery status
When you have the external power connected the battery charging status is indicated with a small battery icon which is
filled to solid when the battery is full. When you disconnect the external power the battery remaining time is indicate in the
hours left. 10h means that the radio will operate for the next 10 hours.
Battery charging with 6 levels of charged
capacity. When solid filled, the battery is fully
charged
Battery discharging with indicating the
remaining time in hours, if less the 1 hour it will
show remaining minutes.
Menu access and control
The menu is accessed using the rotary switch at the right
side of the LCD display. To access the Menu you need to
press & hold the rotary switch longer than 1 second. If you
press & hold too short it will indicate this on the display.
You just press & hold again longer than 1 sec. to access
the menu.
The Menu has two levels, the Main menu for some general
controls and the Main settings.
Both can be set with a password protection. This can be
used in case you have set all internal settings correct and
want to avoid that the users alter these settings. This can
be set up in Password Prompt.
Menu control
The menu is fully controlled with the rotary switch. The switch has a rotating function, left and right. Which are clicks, each
click is one step. The switch also has a push function which you use to enter the menu, select, confirm and return in the
menu.
Vol. Tender
32
+
-
Vol. Tender
32 10h
+
-
+
-
Rotate CW to
increase value
Rotate CCW to
decrease value
OK
Press to enter,
select, confirm and
return
1S
Press & Hold
for >1 sec. to
enter Menu
Rotary switch functions
Rotate CW to go
forward in Men u
Rotate CCW to go
backwards in Menu
