Jumper links selection:
Zone jumper links:
Z1
Z2
PIR LED ENABLE / DISABLE
When the PIR sensor detects body movement, the green LED will flash for
approximately 5 seconds indicating transmitting. Disabling the PIR LED will not affect
the sensing function, but can
save power
.
JP2 jumper:
Jumper removed
LED disabled
Jumper
installed
LED
enabled
< factory default >
PIR POWER SAVE ENABLE / DISABLE
In power save mode, the PIR sensor will not transmit a signal after it has been
triggered for approximately 5 minutes. When a PIR sensor is in power save mode, it
will transmit a signal when it detects body movement once. Within the next 5
minutes, even it has been re-triggered by body movement, it will not transmit a signal
to
save power
.
JP1 jumper:
Jumper removed
Power save enable
Jumper
installed
Power
save
disable
<factory default >
Note: Jumpers Z1 and Z2 are not used with your system
3. After configuring the jumpers if necessary, refit the front cover on the sensor. You
are now ready to test it.
Note: Ensure the front cover is refitted otherwise the PIR will not detect at the
correct range
TEST YOUR SYSTEM
With the sensor installed, check that it functions correctly as follows:
1. Arm your system using the keypad
2. Wait for the 30 seconds exit period and the siren beeps once (or will continue
to beep during the exit period if the JP2 jumper on the siren is removed).