INSTALLATION STEPS
POWERING THE PIR SENSOR
1) Separate the front cover from the rear casing by simply pulling the two apart.
2) Insert 2 x AA alkaline batteries in the battery compartments.
3) The ‘+’ signs on the batteries must match the ‘+’ in the battery compartment.
4) Do not refit the front cover at this stage as you still need to link the sensor to the
external siren.
5) Allow approximately 1 minute for the PIR to warm up and function correctly
LINKING THE SENSOR TO THE EXTERNAL SIREN
For the system to function properly, the external siren needs to learn the unique code
of this sensor.
IMPORTANT: If your alarm system is already installed and you are adding this
accessory to the system, then you will need to remove the external siren from
the wall.
It is advisable to wear ear defenders when removing the siren from the wall as
the tamper alarm will sound when activated. Another person will be needed to
disarm the siren from the keypad immediately.
1. With the siren removed from the wall, remove its rear cover.
It is advisable to wear ear defenders at this stage during the learning process
also as the siren will sound and is very loud.
2. Press the LEARN button once on the siren to enter learn mode. The red learn LED
will be lit on the pcb for approximately 30 seconds.