Novakon Systems NM-200 Pro Series, Руководство оператора

Страница: 12 / 47

Chapter 4
INSTALLATION & SET-UP
4.1 SET-UP CLEARANCES & CONDITIONS
When considering the permanent location for your CNC machine the following should be taken
into consideration:
•
The machine should be installed on a flat surface so that the machine does not rock or
slide during operation.
•
This location should be considered the machine’s permanent location. If you need to
move it, remove it from the stand first.
•
Make sure your stand is level prior to placing the machine on stand. Improper
installation and an unleveled machine can cause both numerical error and loss of
precision in your machining operation.
•
Set up the bed mill stand so you have plenty of working space. Leave at least 3 to 4 feet
of clearance on the operating side of the machine.
A Dimension B Dimension C Dimension D Dimension
NM-200 Bed
Mill 83 in/2110
mm 20 in/500
mm 67 in/1700
mm 81 in/1700
mm
Table 4.1 Clearance Dimension
4.2 POWER REQUIREMENTS
Voltage Amps Amps
NM-200 Bed Mill 220 15 Single
Table 4.2 Power Requirements
4.3 STAND REQUIREMENTS
You will need a stand that is capable of supporting the weight of your machine plus the
maximum allowable work piece depending on your bed mill. You will also need to add in this
figure additional weight for work holding devices, cutters and coolant. A good rule is to build a