Nova gear NG-2102SPD, Инструкция по эксплуатации

Страница: 18 / 24

18
!
Warning: Never pull the cutting head
and spinning blade towards you when
making a sliding cut. The blade may try
to climb up on top of the work-piece,
causing the cutting head to ‘kickback’
forcefully.
DEPTH STOP
The adjustable depth stop is located on
the left hand side of the cutting head.
The downward travel of the cutting head
can be limited so that the saw blade does
not completely cut through the work-piece.
This facility allows you to cut slots in a
work-piece.
NOTE: The depth stop is usually employed
in conjunction with slide cutting.
NOTE: It is advisable that the depth of cut
is checked using a scrap piece of timber to
ensure that the slot cut is correct.
By making a cut in the work-piece,
and then repeating the cut on the
work piece slightly repositioned to the left
or right, it is possible to perform trenching
cuts.
To use the depth stop follow the procedure
below:
1. Loosen the locking nut (Fig. 23).
2. Adjust the depth stop screw to limit the
saw blades travel to the required depth.
3. Once set to the desired depth, tighten the
locking nut against the retaining
bracket to lock the depth stop screw and
ensure that there is no movement.
6. When cutting is complete, return the
depth screw to its normal service position.
This will allow the cutting head to be
locked in the down position by the head
latching pin.
Fig.23
8. Always push the cutting head to the full
rear position during each cut.