LED SPOT 150W Product Datasheet
LED SPOT 150W Product Datasheet
06
05
Cautions:
6.
INSTALLATIONS
7.
CONTROL CONNECTION
For added protection mount the fixtures in areas outside
walking paths, seating areas, or in areas where the fixture
might be reached by unauthorized personnel.
Before mounting the fixture to any surface, make sure that
the installation area can hold a minimum point load of 10
times the device’s weight.
Fixture installation must always be secured with a
secondary safety attachment, such as an appropriate
safety cable.
Never stand directly below the device when mounting,
removing, or servicing the fixture.
from a ceiling, or set on a flat level surface (see
illustration below). Be sure this fixture is kept at least
0.5m (1.5 f t) away from any flammable materials
(decoration etc.).
Always use and install the supplied safety cable as a
safety measure to prevent accidental damage and/or
injury in the event the clamp fails.
Connect the provided XLR cable to the female 3-pin XLR output of your controller and the other side to the male 3-
pin XLR input of the moving head. You can chain multiple Moving head together through serial linking. The cable
needed should be two core, screened cable with XLR input and output connectors.
Please refer to the diagram below. DMX-512 connection with DMX terminator.
For installations where the DMX cable has to run a long distance or is in an electrically noisy environment, such as in
a discotheque, it is recommended to use a DMX terminator. This helps in preventing corruption of the digital control
signal by electrical noise. The DMX terminator is simply an XLR plug with a3 resistor connected between pins 2 and
3, which is then plugged into the output XLR socket of the last fixture in the chain. Please see illustrations below.
Mounting points:
Overhead mounting requires extensive experience,
including amongst others calculating working load limits, a
fine knowledge of the installation material being used, and
periodic safety inspection of all installation material and
the fixture. If you lack these qualifications, do not attempt
the installation yourself. Improper installation can result in
bodily injury.
Be sure to complete all rigging and installation procedures
before connecting the main power cord to the appropriate
wall outlet.
Clamp Mounting:
The LED SPOT 150W provides a unique mounting
bracket assembly that integrates the bottom of the base,
and the safety cable rigging point in one unit (see the
illustration below). When mounting this fixture to truss be
sure to secure an appropriately rated clamp to the
included omega bracket using a M10 screw fitted through
the center hole of the “Hanging Kit”. As an added safety
measure be sure to attached at least one properly rated
safety cable to the fixture using one of the safety cable
rigging point integrated in the base assembly .
DMX512 IN
DMX512 OUT
120
Ω
Signal (-)
Signal (+)
1
2
3
Ground
3
Signal (+)
2
1
Signal (-)
DMX IN
POWER IN
INSTALLATION DIAGRAM
Safety Cable
1/4 Turn
1/4 Turn
Hanging Kit
Safety Clamp
Fuse
Power Switch
POWER IN
DMX OUT
DMX IN
