Notifier ID50 SERIES, Инструкция по установке, пусконаладке и конфигурации

Страница: 40 / 94

ID50 Series Panel - Installation, Commissioning & Configuration Manual
Commissioning
34 997-263, Issue 4
September 2002
3 Using the numeric keypad, press ‘
6
’ to select the
Commissioning option and confirm using the ‘
5
’
pushbutton. The Commissioning option is
automatically displayed if a Level 3 passcode was
previously entered.
If a Level 2 passcode was entered the LCD prompts:
4 Enter the correct Level 3 passcode using the numeric
keypad and confirm using the ‘
5
’ pushbutton (or
press ‘
4
’ to cancel the last operation).
4.7 Commissioning Tests
The following paragraphs list tests that should be performed
after configuration has been completed. A successful result
from these tests indicates that the panel is working properly.
4.7.1 Test LEDs
This procedure is described in the ID50 Series Panel -
Operating Manual, 997-264, Section 4.8.1 .
4.7.2 Test LCD
This procedure is described in the ID50 Series Panel -
Operating Manual, 997-264, Section 4.8.2 .
4.7.3 Test Zones
This procedure is described in the ID50 Series Panel -
Operating Manual, 997-264, Section 4.8.3 .
4.7.4 Test Auto High Test
This procedure is described in the ID50 Series Panel -
Operating Manual, 997-264, Section 4.8.4 .
4.7.5 Test Outputs
This procedure is described in the ID50 Series Panel -
Operating Manual, 997-264, Section 4.8.5 .
4.7.6 Test Buzzer
This procedure is described in the ID50 Series Panel -
Operating Manual, 997-264, Section 4.8.6 .
4.7.7 Test Keyboard
This procedure is described in the ID50 Series Panel -
Operating Manual, 997-264, Section 4.8.7 .
[S1 COMM] 1:Setup 2:Circuit
3:CBE Rules 4:Zones 5:Access × : More
COMMISSION MODE ACCESS
Enter Level 3 Passcode: . . . . < : BackSp
[S1 COMM] 1:Setup 2:Circuit
3:CBE Rules 4:Zones 5:Access × : More
6 5