Page of 8
5
down with the cup holder toward the Tray (3) and the hand holes on the outside. Using a rubber
mallet, tap the Handle (5) down into the grooves on the Tray (3) - see Figure A.
2. Locate the two Beams (7). Place one on the Tray (3) corner nearest the Handle (5), and place
one on the diagonal corner located on the outside of the Tray (3) as in the Assembly diagram.
Make certain that the end with the screw holes is facing upward. Using a rubber mallet, tap the
Beams (7) down into the Tray (3).Note: Position the Beams so that the flange in each matches
the space in the Tray (3). - see Figure B.
3. Locate the two Beams (8). Place one on the Tray (3) corner nearest the Handle (5), and place
one on the diagonal corner located on the outside of the Tray (3) as in the Assembly diagram.
Make certain that the end with the screw holes is facing upward. Using a rubber mallet, tap the
Beams (8) down into the Tray (3). - see Figure B.
4. Inserts Screws (4) down through each Beam (7) and Beam (8) and into the Tray (3) - see Figure
B.
5. Locate the second Tray and turn it upside down. Set the second Tray (3) onto the Beams (7 &
8), locate it in the middle of Beams, secure the Tray into the brackets on the Beams - see Figure
C.
6. Locate the third Tray and turn it upside down. Set the third Tray (3) onto the Beams (7 & 8)
making certain that both Trays (3) are facing the same way. Inserts Screws (4) down through
the Tray (3) into each Beam (7) and Beam (8) - see Figure D.
7. Turn the Service Cart right-side up. Set the Corner Covers (1 and 2) down onto each corner of
the top Tray (3) - see Assembly diagram.
8. Turn the Service Cart upside down again. As necessary, attach one Caster (11) to each of the
two Brackets of Swivel Caster (9) using one Bolt (12) and secured in place with Nut (10) – see
Assembly diagram.
9. As necessary, attach one Caster (11) to each of the two Fixed Casters (13) with Bolt (12), and
Nut (10).
10. Place the two Brackets of Swivel Caster on the same side of the Tray as the Handle (5), and
place the two Fixed Casters on the rest side of the Tray- see Figure E.
11. Thread Bolts (17) down through the Tray (3) and into the Casters (9 and 13). Slide on Split
Washer (14) and thread on Nuts (16).
12. Turn the Service Cart upright. Make certain that all hardware is tight. Make certain that the
Fixed Casters and Swivel Casters roll properly.
