Norton TT 250 G, Руководство по эксплуатации

Страница: 13 / 20

13
5 Operating the machine
5.1 Site of work
5.1.1 Siting the machine
•
Remove from the site anything, which might hinder the working procedure!
•
Make sure the site is sufficiently well lit!
•
Observe manufacturer's conditions for connecting to power supplies!
•
Place electric cables in such a way that damage by the device is excluded!
•
Make sure you have a continual adequate view of the working area so you can intervene in the
working process at any time!
•
Keep other staff out of the area, so you can work securely.
5.1.2 Space required for operation and maintenance
Leave 2 m in front of the machine and 1,5 m around it for usage and maintenance of the TT250G.
5.2 Cutting methods
To use the machine correctly, you must face it with the two hands on the tile to be cut, pushing the
tile against the blade. Always keep your hands away from the moving blade.
5.3 Bevel cut
•
Loosen the two screws (1) on each side of the machine.
•
Pivot the table until you reach the desired angle.
•
Fix the table with the screws (1). Adjust the distance to blade in regard to the tile to be cut.
5.4 General advice for the cutting
•
Tiles can be cut with the machine. Before commencing work make sure tools are firmly seated!
•
Select the right tools as recommended by the manufacturer depending on the material to be
worked, the working procedure (dry or wet cut) to be carried out and the required efficiency.
•
Make sure the water pan contains enough water.
•
Set the guide-a-cut to the desired width of cut, using the two engraved measurements to align it
correctly.
•
Do not force on the motor. This machine is designed for a continuous use.