Norton Clipper C1318P, Руководство пользователя

Страница: 12 / 34

12
C. Water Supply
Pressurized source:
Turn the water control to full "ON" when using wet
cutting blades. The required flow rate is 4-6 gallons per minute.
Water Tank on saw:
This supply is designed for use with dry blades to
keep the dust levels down. The tank will not supply the proper water flow
rates when used with wet cut only blades. Do not drink the water from this
tank. Fill the tank with water only. Close the water tank valve. Attach the
saws water supply hose to the tank outlet. Fill the tank with water. The
capacity of the tank is 6.5 US Gallons
(24.6 liter) . When you are ready to
cut, adjust the water supply rate until a fine mist or a slow trickle is made.
The use of water greatly decreases the amount of dust produced during the
cutting process, aids in the cooling of the blade, and provides additional
stability.

Use Only Water In The Water Tank

Do Not Drink From The Tank
D. Operating the Saw
1. For blade installation instructions
see section II. Operation sub heading
A. Installing the Blade . For the engine starting instructions, see the
Engine manual and follow the instructions located in section II. Operation
sub heading B. Starting the Engine .
2. Check the Engine Oil level.
3. Raise the saw to the full upright position. Do not let the blade come in
contact with the ground.
4. Maneuver the saw to the desired starting point.
5. If wet cutting, connect the water supply to the saw.
6. Follow the instructions for starting the engine found in the Engine manual.
7. If wet cutting, turn on the water supply at the source and then open the
water valves on the saw. Make sure that there is a minimum of 4-6 gallons
per minute of water flow!!
8. Be sure the engine is running at full throttle!!!
9. Slowly lower the blade by rotating the hand wheel clockwise until the
desired depth of cut is reached. Use a reasonable rate of feed. Do not
force the blade into the cut!!