9
05278B-2
OWNER’S MANUAL #
39202
ver.
05278B-2
PAGE # 9 English Version
PRE-INSTALLATION
NOTES
•
Ensure that the rechargeable Ni-Cad
battery pack is installed inside the
handset battery compartment.
•
Set the STANDBY/SAVE ON switch
on the handset to the STANDBY
position for normal use.
•
It is strongly recommended that the
Ni-Cad battery be fully charged for
at least 12 hours before initial use.
INSTALLATION
CAUTION:
USE ONLY THE NICKEL
CADMIUM (Ni-Cad) BATTERY TYPE
INCLUDED WITH THIS UNIT. USE OF
OTHER BATTERY TYPES MAY CAUSE
INJURIES OR DAMAGE.
Desktop Use
1.
Set the unit on the sele cted desktop
and connect the telephone line cord
to the TEL. line jack on the rear of
the base unit.
2.
Connect the opposite end of
telephone line cord to the telephone
modular jack.
Wall Use
(with a standard AT&T or GTE modular wall
jack)
1.
Connect the short telephone line
cord to the TEL. line jack on rear of
the base unit.
2.
Install and attach the wall mount
bracket onto the bottom of the base.
3.
Connect the opposite end of the
telephone line cord to the telephone
modular wall jack.
4.
Align the wall mounting slots with
the studs located on the modular
wall plate and slide the base down
to lock in place. See figure 1. below.
(Figure 1)
NOTE:
If you do not have a standard
modular wall jack, have a qualified
technician mount one on the wall.
Wall Mounting (No Standard Wall
Jack)
Drill two holes with a vertical
distance between the two marked
positions of 3
15/16
″
(100mm) as shown in
figure 2.
3
15/16
″
(100mm)
(Figure 2)
1.
Drive a screw into each of the holes.
Tighten them to the end of the screw lines,
only leaving the smooth part of the screw
head outside the wall.
2.
Hang the unit onto the screws, then
slide it down
firmly
to fasten the
base securely.
Handset Retainer Tab Setup
If the base unit is to be placed in the wall
mount position, the handset retainer tab
must be pulled out so that the tab allows
Wall
Mount
Bracket
Base Unit
(Side View)
Wall
Mounting
Slots
Telephone
Modular
Wall Jack
Studs
