Northwestern Bell EasyTouch 58100, Руководство пользователя

Страница: 5 / 8

RINGER ON/OFF Switch - Used to turn the ringer ON or OFF.
TONE/PULSE Switch
- Allows you to switch the dialing mode to either Pulse or Touch
tone dialing.
Wall Mount Bracket
- Allows you to
mount the phone on the wall. Use if
desk or table space is limited. See
figure 1.
INSTALLATION
Desktop Connection
Select a location near a telephone
modular wall jack.
1. Plug one end of the telephone line
cord into the LINE jack on the rear
of the 58100.
2. Connect the other end of the
telephone line cord into the
telephone modular jack located on
your wall. See figure 2.
(Figure 2)
Wall Use
(with a standard AT&T or GTE modular wall jack)
1. Connect the short telephone line
cord into the LINE jack on rear of
the base unit.
2. Route the short telephone line cord
through the small hole on the upper
right hand side of the wall mount
bracket.
3. Install the wall mount bracket as
shown on figure 3.
4. Insert the opposite end of the
telephone line cord into the
telephone modular wall jack.
5. Align the wall mounting slot with
the studs located on the modular
wall plate and slide the base down
to lock in place. See figure 3.
(Figure 3)
Handset Retainer Tab Installation
If the base unit is to be placed in the
wall mount position, the handset
retainer tab must be pulled out, turned
around and placed in the opposite
direction, so that the tab allows the
handset to hang onto the base unit, as
shown in figure 4.
(figure 1)