Northwestern Bell Big Button Plus 20270, Руководство пользователя

Страница: 8 / 18

7 010508A-1
can then dial any of the stored phone
numbers by just pressing one of the
emergency buttons located above the
LCD panel.
RE(REDIAL)/PA(PAUSE) Button -
This button allows you to automatically
dials the last phone number dialed up to
32 digits. Pressing the RE/PA button in
the dialing sequence will inserts a 4
seconds pause between dialed numbers.
(for use in PABX or long distance
services)
PULSE/TONE SWITCH - Located on
the rear of the base unit. It allows you
to switch the dialing mode to either
pulse or touch tone dialing.
TONE * Button - Used to temporarily
change the dialing mode from Pulse to
Tone when dialing in the Pulse mode.
Provides tone function to access special
services such as phone banking services.
SPEAKERPHONE Button - Allows
you to place and receive calls without
having to use the handset.
STORE Button - Used to store 10
phone numbers (up to 16 digits each) or
dial any of the stored phone numbers in
the 10 memory locations.
VOLUME Control - Used to adjust the
volume of the speaker when using the
speakerphone.
Visual Ring Indicator - flashes to alert
a person who has trouble hearing that
the phone is ringing.
BATTERY
INSTALLATION
Your unit requires 4 “AA” batteries (not
included). alkaline batteries are
recommended. The battery
compartment is located in the bottom of
the base unit. Carefully remove the
battery cover and follow the markings in
the compartment as shown below:
(Figure 1)
INSTALLATION
Desktop Use
1. Set the unit on the selected desktop
and connect the telephone line cord
to the telephone line jack on the rear
of the base unit.
2. Connect the opposite end of
telephone line cord to the
telephone modular wall jack.
3. Connect one end of the coiled
handset cord to the handset jack of
the base unit (located on the left
hand side of the base) and the other
end to the handset jack of the
handset.
Wall Use
(with a standard AT&T or GTE modular wall jack)
1. Connect the short telephone line
cord to the telephone line jack on
rear of the base unit.
2. Connect the opposite end of the
short telephone line cord to the
telephone modular wall jack.
3. Align the wall mounting slots with
the studs located on the modular
wall plate and slide the base down
to lock in place. See figure 1.
Wall
Mounting
Slots
Battery
Compartment
Telephone
Modular Wall
Jack