Northwestern Bell 76510-1, Руководство пользователя

Страница: 13 / 16

13 11159-A
OWNER’S MANUAL # 76510 ver.11159A-1
PAGE # 13 English Version
HOLD
If you wish to put the caller on hold,
pressing the HOLD button will hang up
the phone momentarily without
disconnecting the call. Replace the
handset to the base. Lift the handset or
other phone connected with the same
line to resume your conversation.
Storing Telephone Numbers Into 10
One-Touch Memory Locations
1. On-Hook state.
2. Press the one-touch (01-10) buttons
to view stored record.
3. Press the STORE button once and
dial the telephone number you want
to store. (Number will not dial out)
4. Press the one-touch memory
location(01-10) where you want the
phone number stored.
5. Repeat steps 1-4 to program the
remaining memories.
6. Remove the plastic cover on the
one-touch (01-20) memory buttons
and write next to the memory button
the name relating to the phone
number just stored into memory.
NOTE: If the location had been
previously pre-stored a number, it will
be replaced by the new number.
To Change A Number In Memory
Location (01-10)
1. On-Hook state.
2. Press the one-touch (01-10) buttons
to view stored record.
3. Repeat steps3-4 described in the
section “Storing Telephone
Numbers Into 10 One-Touch
Memory Locations.”
One-Touch Dialing From Memory
(01-10)
1. Pick up the handset or press the
SPEAKERPHONE button.
2. Select and press the desired one-
touch button from the 10 one-touch
buttons located below the LCD
panel. The telephone number
appearing on display will be dialed
automaically.
Transferring And Storing Phone
Numbers From An In-Coming Call
(70 Calls) to Memory Locations (01-
10).
1. On-Hook state.
2. Press the REVIEW ► or ◄ button
to select the desired phone number.
3. Press the STORE button.
4. Press the desired one-touch button
from the 10 one-touch memory
locations.
5. To transfer and store more phone
numbers in memory, repeat steps
1-4.
NOTE: Number stored previously in
the selected location will be replaced by
the one recently stored. To prevent
number from being deleted accidentally.
You are advised to view the memory
location (01-10) record before storing
the number.
Viewing the Stored Number
1. On-Hook State.
2. Press the desired one-touch memory
button.
3. The pre-stored phone number and
location number will display. If no
number was previously stored, the
display shows only the location
number.
Storing Two Touch Memory
1. Pick up the handset (or activate the
speakerphone)
2. Press and release the STORE button.
3. Enter the phone number up to 16
digits)
4. Press and release the STORE button.
5. Press location number (0-9) on the
keypad where you want the number to
be stored.
6. To store more phone numbers or
modify existing numbers in memory,
repeat steps 1-5.