Supertow II Setup
CHAIN ADJUSTMENTS
After some use your chain may loosen up. Your machine may jump, experience chain noise or
grinding. You can tighten the chain in this manner. This is a unique chain tightening system.
Follow this procedure closely. Questions call 800-635-5565.
Loosen jam nut and back out
back bolt part way.
You have 3 drive chains on the “Supertow
II
”
Two drive chains to the tires and one from
transmission to the differential.
Start
with the 2 forward drive chains. Loosen the
3 Jam Nuts from the front of pillow blocks do not
back out the bolts, just loosen the nuts.
Adjuster Bolt
Jam Nut
Slotted Pillow
Block Bearings
Zirk Fitting
Loosen all the bolts holding down the pillow block bearings
Tighten the Adjusters bolts evenly against all three pillow blocks; until chain is comfortably
tight (Do not over tighten) Tighten jam nuts or your bolts will back out over time. Securely
tighten the bolts holding pillow block bearings. The pillow blocks are slotted also.
Last…Retighten the back bolt against pillow block and tighten jam nut.
This has tightened the drive chains. Now you will need to slide the engine plate back towards
the handle to remove the chain slack from the transmission to differential. You will need to
tighten this chain also.
