KMT131611-1
ASSEMBLY INSTRUCTIONS
Step 1: Verify Package Contents and Assemble Poles
Tent : 1 each
1) Assemble the roof frame as shown below matching color coded poles to color coded connectors. Use the diagram below and the replacement
parts listing on page 4 as reference. Make certain the metal springs lock into place on all the connectors.
2) Attach ridge, roof and eave poles:
(H) WHITE Ridge Pole. Attach brass s-hook on the tent to middle ridge connector.
(I) GRAY Eave rear pole
(D) GREEN Roof Corner poles
(E) IVORY Roof middle poles
(A) RED Ridge front poles
(B) YELLOW Roof front poles
(C) PINK Eave front pole. Attach brass s-hook on the tent to middle ridge connector.
(G) BLUE Eave side poles
2) Assemble steel poles by inserting the
tapered ends into the adjacent sections.
Assemble fiberglass poles by placing
sections into the metal ferrules.
1) Verify package contents as listed below
Steel poles : 25 each (total)
( ) denotes color coding
Rainfly : 1 each
IMPORTANT NOTES:
* Assemble your tent before camping to become
familiar with the assembly.
* Two people are recommended for setup.
* Select a clean, level area for the campsite free
of debris and sharp objects, away from a
natural watercourse.
* Use of a ground cloth is recommended to
prolong the life of the tent floor and provide
additional insulation and moisture protection.
* To prevent damage to the zippers, unzip the
doors and windows of the tent prior to
disassembly allowing air to move freely.
* Seam seal the inside stitched seams of the tent.
This will improve weather resistance. Available
in sporting goods departments. Discoloration
may occur if applied to outside seams.
Hanging Shelf : 2 each
Mud mat : 2 each
Tent Stakes : 20 each
Fiber glass poles : 2 each (total)
Color Coded Conectors - 12 each
(A) Ridge front (red) - 2 each
(B) Roof front (yellow) - 4 each
(C) Eave front (pink) -1 each
(D) Roof side (green) - 4 each
(E) Roof middle (ivory) - 2 each
(F) Leg (orange) -7 each
(G) Eave side (blue) - 2 each
(H) Ridge (white) - 1 each
(J) Closet - 2 each
(I) Eave rear (gray) - 1 each
Step 3:
Assemble roof frame
Step 2: Spread and stake tent
1) Spread out the tent floor side down on a
flat, clean and level area.
2) Stake down the tent by inserting a stake
through the stake loops, located along the
perimeter of the tent.
3) Hammer the stakes into the ground at a 45
degree angle using a hammer or mallet.
4) Make certain the tent floor is pulled out
evenly and tightly.
I
E
H
E
C
B
A
D
G
D
D
G
D A
B
4
1
8
5
7
3
2
12
10
A
H
C
B
B
B
A
B
D
D
G
1
6
E
KMT131611-1 09/13
