Using a funnel, empty the entire
contents of the 2 bottles of engine oil
supplied with the product into the
motor crankcase, through the
dipstick hole. Check the oil level
before use.
Install the supplied Orange 18mm
American BSP tap adaptor into the
water inlet.
DO NOT overtighten the tap adaptor
as this could cause damage to the
water inlet fittings .
Fill the petrol tank located on the top
of the pressure washer with Unleaded
Petrol.
Attach the high pressure hose onto the
pressure washers outlet connector,
then connect the other end of the high
pressure hose onto the pressure gun
connector. Turn ON your water supply.
Connect your 18mm water supply
hose onto the Orange tap adaptor
fitting.
Starting the motor can be achieved by
pulling the recoil starter handle repetitively
until the engine has started. Once started
move the choke lever to the open position.
Slide the metal throttle lever to the Left to
increase the motors power.
Squeeze the trigger of the pressure gun to
purge all air from within the pressure
washers pump, hoses & fittings. Continue
until a constant stream of water is visible,
insert nozzle suitable for your application.
Turn fuel valve to the ON position,
rotate start switch located on the
side of the motor body to the ON
position
If the engine is cold, slide the choke
lever fully to the left (closed choke) if
the engine has already been run or is
warm then you may not need to move
the choke lever prior to starting.
11
12
13
14
15
16
17
18
19
QUI
CK
ST
AR
T G
UI
DE
Have questions relating to assembly or operation of your product, call KINCROME on
1300 657 528
Page 2/2
SC
AN
TH
E
Q
R C
O
DE
W
ITH
Y
O
U
R
M
O
BIL
E
DEV
IC
E
TO
V
IEW
T
HE F
U
LL
SET
U
P
&
O
PE
RA
TIO
N
V
ID
EO
F
O
R
TH
IS
ITE
M
.
PART NO. NS15781520
NorthStar
4000PSI Cold Water
Petrol Pressure Washer
THESE INSTRUCTIONS ARE TO BE USED AS A GUIDE ONLY AND ARE NOT INTENDED TO REPLACE THE FULL INSTRUCTION MANUAL PROVIDED WITH YOUR PRODUCT.
ALWAYS READ THE INSTRUCTION MANUAL FOR FULL DETAILS RELATING TO SAFETY INSTRUCTIONS, ASSEMBLY, OPERATION AND MAINTENANCE OF YOUR PRODUCT.
ALWAYS MAKE SURE YOUR PRESSURE WASHER IS ON STABLE LEVEL GROUND BEFORE CHECKING OIL LEVELS.
